Getting The Best Swim Spa Cover

Swim Spas represent distinct difficulties when it pertains to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the Swim Spa Cover can be a lot more difficult.
Getting a new swim spa is an amazing event in life. You’re looking forward to the exercise you’ll get from using it. Perhaps you’re a little relieved to have actually lastly selected from the various models you looked at. At any rate, you probably weren’t thinking much about the Swim Spa Cover you would use.
Normally, the cover that gets back with your new purchase will be a 4 area stiff foam filled Swim Spa Cover that will split in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the Swim Spa Cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the Swim Spa Cover
It happens gradually and on a Swim Spa Cover which is made from specific sections, at differing speeds. So ultimately you’ll notice one or two of the areas are really getting heavy. The bar lifters on completions of the swim spa aren’t much aid due to the fact that you still need to raise that heavy Swim Spa Cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different design for their Lightweight Swim Spa Covers
Instead of using several foam panels that will eventually end up in some land fill, they designed Lightweight Swim Spa Covers that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to use, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these Lightweight Swim Spa Covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to buy today, bookmark this website so you can find it again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *